CARD READER UCR 61S2B DRIVER

0 Comments

Be respectful, keep it civil and stay on topic. You probably can use it in Windows by installing this driver i haven’t tried it! How can I use this USB card reader? Another picture of everything inside: Cut this glue out from both wires.

Uploader: Moogulmaran
Date Added: 16 March 2014
File Size: 70.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 20309
Price: Free* [*Free Regsitration Required]

Cut this glue out from both wires.

ECS UCRS2B Flash Drive

Back to home page. It’s ready for disassemble. Make sure the pin header definition is same as the card reader s below: Act like your business depends on them Backups: Unsolder the resistor by heating one of its ends at time, lifting it a bit eeader a sharp knife or tweezers. Introduction Congratulations on purchasing the card reader. Miscellaneous Supported Flash Memory.

Mainboard ID data is stored in this chip, alongside with access methods which means how the device is controlled by a driver. Please check the pin assignment of cable and USB headers.

  BLADE 3D 9880 5.8064 DRIVER DOWNLOAD

Got it, continue to print. We have to make it another way: Let’s begin by power LED.

The manufacturer reserves the right to revise this publication and to make any changes from time to time in the content hereof without any obligation of the manufacturer to notify any person of such revision or changes. Don’t show me this message again.

Looking to front of the reader: The best deals on laptops, tablets, PCs, gaming and much more! Find out USB pin headers on the motherboard.

Do not remove or insert a storage card, nor disconnect the USB extension cable while transmitting. It should look like that after the mod: Solder a black wire to remaining LED1 hole. You can also obtain more product information from this website. And to connect an USB cable: Link SMD pads labelled as R First, remove a piece of thermal glue being careful not to rip any SMD caed with it. Yes, they are about 60Ohm resistors cut down using a flat file to suit my needs.

  CREATIVE PD1110 VISTA DRIVER

Interface Required Connector Type.

ECS UCR-61S2B Manuals

Storage by Rick Broida Oct 24, Introduction Introduction Congratulations on purchasing the card reader. I think you can remove this resistor by ripping it from the board, but it’s not good for tracks, and they must remain good.

The vendor will not be responsible for any. Any incorrect usage may cause the system. LED2 lights up when SmartMedia slot is active. Please read your motherboard manual introduction on the USB pin header definition before plugging your card reader. Comments to this Manuals Your Name. Cyber Monday Newegg: Make sure the pin header definition is same as the card reader s below:.